Show simple item record

dc.contributor.supervisor Shafai, Cyrus (Electrical and Computer Engineering) en_US
dc.contributor.author Chen, Tao
dc.date.accessioned 2018-09-24T15:03:15Z
dc.date.available 2018-09-24T15:03:15Z
dc.date.issued 2018-09 en_US
dc.date.submitted 2018-09-17T23:20:34Z en
dc.date.submitted 2018-09-24T03:17:34Z en
dc.identifier.uri http://hdl.handle.net/1993/33461
dc.description.abstract This thesis explores several types of micromachined electric field sensors to address the main drawbacks of traditional electric field mills, namely high power consumption, big size, and the requirement of frequent maintenance. Micromachined devices possessing significantly smaller size, less power to move mechanical parts, and free of rotating parts, therefore avoid the wear and tear of moving elements. Two types of sensors were designed. One is based on electrostatic force deflection, and another is based on a vertical movement shutter type field mill. Compared to other micromachined electric field mill (MEFM) sensors, both types of sensors overcome the issue of grounded shutter displacement under a large electric field and provide comparable or even higher performance. Two force deflection actuators were designed and fabricated – SOI membrane and metal ribbon array. Capacitance measurement was applied to both actuators, and both show the ability to measure fields greater than 50 kV/m. When use a laser monitor system to test the SOI membrane, similar sensitivity was achieved. In addition, the ac modulated method was applied to improve the sensitivity of the optical measurement. Providing 118.8 V (peak to peak) ac bias signal on the SOI membrane, sensitivity of 20 V/m was achieved with the ac modulated method. The vertical movement shutter field mill is a novel design. It employs bimaterial thermal actuators to provide vertical movement for the grounded shutter. It solves the problem of shutter displaced under the large field problem in existing micromachined electric field mills (MEFMs). Three types of bimaterial thermal actuators were modeled: SiO2-Al, SU-8-Al, and Si-Al. Due to the high stress of SiO2, the first attempt was to fabricate a SU-8-Al actuator. However, it was found that SU-8-Al actuator has a permanent deformation issue at high temperature. Then efforts were focused on the Si-Al actuator, and the device was successfully fabricated. The sensor mechanical performance test shows that the shutter movement agree with the simulation at various temperature between 25 – 100 ºC. When drive the thermal actuator by digital hot plate, the measured induced current generated by an alternative electric filed also agree with the calculation. en_US
dc.subject Electric field, electric field measurement, electric field mill, MEFM, MEMS, micromachining en_US
dc.title Micromachined electrostatic force and vertical field mill ac/dc electric field sensors en_US
dc.degree.discipline Electrical and Computer Engineering en_US
dc.contributor.examiningcommittee Rajapakse, Athula (Electrical and Computer Engineering) van Lierop, Johan (Physics and Astronomy) Tait, Niall (Electronics, Carleton University) en_US
dc.degree.level Doctor of Philosophy (Ph.D.) en_US
dc.description.note February 2019 en_US


Files in this item

This item appears in the following Collection(s)

Show simple item record

View Statistics