Design and experimental evaluations of a pump-controlled hydraulic circuit
Loading...
Date
2016
Authors
Jalayeri, Ehsan
Journal Title
Journal ISSN
Volume Title
Publisher
Abstract
This thesis presents a novel, low cost, high precision , and efficient design for an electro-hydrostatic circuit for single rod hydraulic cylinders. The design is the main contribution of candidate to fulfill the regiments of PhD degree. The challenge of existing deigns of electro-hydrostatic circuits for single-rod cylinders is using one pump to control the cylinder under switching (resistive-assistive) loads. The proposed circuit utilizes off-the-shelf industrial elements. It uses two counterbalance valves to manage switching loads and one on/off solenoid valve to redirect the differential flow of the single rod cylinder to tank. A set of simulation studies is conducted using Simhydraulic tools of Matlab in order to study performances of the proposed circuit and compare it with existing designs. Pump-controlled hydraulic circuit for double rod cylinders was developed and is widely used by industry. It is used as the benchmark for simulation studies. As well, the proposed circuit and two major existing pump-controlled circuits for single rod cylinders are compared to the benchmark circuit. Evaluations are conducted by comparing chamber pressure responses as well as pressure vs position of the cylinder end-effector for each individual circuit. Results indicate that the proposed circuit performed as well as the benchmark circuit by controlling pressures to both sides of the cylinder at the same time. Moreover, the load in the proposed circuit is more controllable compared to the benchmark circuit. Experimental results, obtained from the developed test rig, validate accuracy of the simulation model. Maximum steady state position error of 0.06 mm applications is experimentally observed when the test rig is tested under different loading conditions with various amplitudes and frequencies. The circuit consumes up to 20% of the energy that is required by a valve controlled circuit given the same sinusoidal tracking signal. The relative efficiency of the proposed circuit over a valve
xii
controlled circuit depends on the pattern and frequency of the tracking signal. In all the experiments, a simple proportional controller, which uses readings of a linear position transducer, is employed. The use of the proportional controller makes the proposed circuit easy to implement and shows it is good candidate for industrial applications. The accuracy of the position response of the proposed circuit indicates, it is a good candidate for robotic applications too.
Description
Keywords
Design, pump-controlled hydraulic circuit, Gear pump, Piston pump, Counterbalance valve, Pilot check valve, Fixed displacement hydraulic pump, Variable speed