Show simple item record

dc.contributor.authorGoel, Sandeepaen_US
dc.date.accessioned2007-05-18T19:58:48Z
dc.date.available2007-05-18T19:58:48Z
dc.date.issued2000-10-01T00:00:00Zen_US
dc.identifier.urihttp://hdl.handle.net/1993/1790
dc.description.abstractAn important aspect of many quality improvement initiatives launched by manufacturing firms consists of either (i) making the rework and interim part scrap an integral part of their manufacturing process, or (ii) select a process with a process capability higher than cost Justifiable, or (iii) increasing the process automation. Whereas these efforts are justified, difficulty to quantify the benefits of the resulting "higher quality levels" has led many critics to stigmatize the initiative as a 'quality-at-any-cost ' scheme. In this thesis, a systematic problem solving approach is developed to (i) understand the process and the problem, (ii) identify the ources) of the problem, (iii) model the process, (iv) test the specification or the given conditions if they can be met, and (v) develop a simulation model for the process to allow continuous tracking of quality, cost and time. The prefit process used for verifying the required mating conditions for detail parts that make up the bonded assembly, and their specified dimensional tolerances were found to be the main problems causing assembly nonconformance. During the prefit process, the detail parts are made to fit like a jigsaw puzzle on a simulated bond tool, and gaps between all associated joints are verified to meet the requirements for the bond line thickness on the final bonded assembly. If the prefit gaps are not as per the requirements, the cured assembly will have either too thin or two thick bond lines, besides having disbonds, voids or porosity. If these defects are found at the final assembly, the parts have to be scrapped, as no rework is possible at this stage. It is therefore, imperative that attention is paid during the prefit stage. In this research, a simple spreadsheet simulation approach was developed to test the detail part specification and verify if it was theoretically possible to obtain the required gaps at various joints. The approach was then extended to determine the extent of gap compliance, and identify the conditions under which gap compliance could be achieved. Finally, a stochastic dynamic (SD) simulation model for the prefit process of atypical metal bonded assembly, the Main Landing Gear Door, was developed. (Abstract shortened by UMI.)en_US
dc.format.extent12079731 bytes
dc.format.extent184 bytes
dc.format.mimetypeapplication/pdf
dc.format.mimetypetext/plain
dc.language.isoengen_US
dc.rightsinfo:eu-repo/semantics/openAccess
dc.titleA simulation approach to track quality, cost and time during the manufacture of metal bonded assembliesen_US
dc.typeinfo:eu-repo/semantics/doctoralThesis
dc.typedoctoral thesisen_US
dc.degree.disciplineMechanical and Manufacturing Engineeringen_US
dc.degree.levelDoctor of Philosophy (Ph.D.)en_US


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record